How To Install Ceiling Spotlights
Installing recessed spotlights? Here's how!
Installing recessed spotlights can be complicated for some. Nonetheless, with our instructions information technology can be an piece of cake job!
What you lot demand:
-
Tape-measure
-
Pencil
-
Screwdriver
-
Electric tester
Step i. Turn off the power and read the instructions properly
Switch off the ability earlier you starting time installing. The dimensions of the recessed lights are on the instructions sail, the distance of installation between the recessed light and wall is usually one meter, however the space in between each recessed light is upward to you and what your preference is. Measure where you desire each recessed light to be installed by mark a pencil on the ceiling.
Step ii. Drill the marked holes for each spot in the ceiling
Earlier y'all commencement drilling, you will need to ensure that the right size hole is drilled. Past now you lot should know what the built-in depth and diameter of each recessed spotlight is, if y'all over drill by few millimeters it doesn't matter that much. Ensure you are wearing protective eye goggles while drilling.
Step iii. Insert the recessed spotlights
After drilling infinite for the recessed spotlights to be installed, make sure you check that you take electricity for each pigsty drilled past using the electrical tester. In one case y'all confirm that there is a electric current flowing to each hole, switch off the power. Every spotlight has an opening crown where main wires are connected, connect the black and blue wire to the opening and secure it into place past using a screwdriver to tighten it. If the spotlight is earthed, you must also adhere the earth wire (yellow-green wire) to the opening crown which is located in the middle. Push all electrical wires into the ceiling and out of sight, lock the springs in identify and insert the spotlight into the pigsty and fully fit it in. Repeat this step for all remaining recessed spotlights.
Annotation:
Spotlights tin be come up very hot when using halogen bulbs, this emits rut and may cause fire. If the recessed spotlight is not fire rated do not install in any area where there is insulation material in the ceiling. You must purchase fire hoods or fire caps if you lot wish to install a non fire rated recessed light.
Pace 4. Insert bulbs
Finally, insert the bulbs into your spotlights. Depending on the type of recessed spotlight you have installed, the bulbs can be installed with the spotlights fully fitted or you volition need to insert them through the ceiling which means clipping the springs.
Stride 5: No transformer is required for each recessed spotlight.
Do you lot desire to install multiple recessed spotlights using 1 transformer, only you only have one master ability connection? In this case you are able to create a daisy chain by hands creating a loop. The mains connection yous initially installed each recessed light, take a new bluish and black wire and connect it to the side by side installed recessed low-cal. Continuously repeat this until you have done so for all of your lights, if its earthed ensure that y'all also connect the globe wire (yellow-green) through the heart final and exercise the same for all lights.
If you require assistance or have questions, please contact us.
We are available during the following opening hours:
Source: https://www.lampandlight.eu/installing-recessed-spotlights
Posted by: nashgrea1959.blogspot.com
0 Response to "How To Install Ceiling Spotlights"
Post a Comment